rss
RSS
csende
Search
News
New products in our catalogue
Image

New products from our catalogue should arrive at the market during the following days. These products have passed  careful development and testing:

Main Switch:
An electronic switch for the power battery inside the model.

Duplex R7 nano:
The smallest Duplex receiver with the weight of 1g.

Advance 10 Pro:
A lightweight controller without BEC for indoor models.

MSPEED 450:
An airspeed sensor up to 450km/h.

MAX BEC 2D Plus:
Voltage regulator with the support of RC Switch.

EnLink 2RS Plus:
An intelligent signal merger for servos and PPM.

Congratulation to Henning Wessels
Image
Henning Wessels won the first German F3A DMFV competion. He uses the JETI DC-16 in combination with the Mezon 95 speed controller. This combination gives a sure feeling for flying the airplane. All data from the Hacker Q80 are accessible for online and offline analysis - rpm, amps, temperatur etc.
Central Box 200 firmware update
Image

This update brings additional options for digital inputs and outputs to the Central Box 200. Now you can simply control your LED lights using the Central Box  only. The Central Box can function as an EX Bus expander so you can join several Central Boxes together and you'll have perfect signal distribution and control redundancy in a model. 

Download here

Connectors

Anti Spark connectors are designed to connect power supply and speed controllers of brushless motors. These connectors are fitted with  a circuit for limiting the charging current to the capacitor controller and thus prevent occurance of electric discharge when connected. Longevity of the connector in terms of the number of connections is extremley enlarged by the elimination of electric discharges. Consequently reliability of the connection is also increased.


Anti Spark connectors are also characterized by low contact resistance and mainly by easy use. Two pairs of connectors are enclosed in the packet, one of them has integrated current limitation. Further on there are 8 heat-shrink tubes in black and red colour for any combinations of connectors plugin.


Anti Spark connectors are available in the size of 4mm, 5,5mm, and 8mm.


Maximum current for  types of the connector:

Type of the connector
ø 4mm ø 5,5mm ø 8mm
Continuous current
75A 150A 300A




Soldering of conductors

Solder proper conductors to the connectors, especially regarding the current load. Firstly solder ASC female connector to the devices for current limitations for capacitor charging. Plug in not used male connector just half way into this female connector. This male connector will function for heat dissipation when soldering and thus prevent melting of the tin on the soldered part with the devices.

Solder remaing connectors in usual way. In case the connectors are contaminated by soldering flux (e.g. rosin) during the soldering, clean the connectors sufficiently, e.g. with ethanol.

In the packet of Anti Spark connectors, there are also heat-shrink tubes that are to be slided onto the connectors and shrunk with hot air gun in the place of solder joint of the connector and the conductor.

In case you solder connectors to the power supply, make sure not to connect positive and negative poles of the accumulator.


Warning

The connector contains fragile ceramic components, please handle it with care.

Ordering type
Show

Anti Spark 4,0mm

Art. No.: JMS-ASC4
Anti Spark 4,0mm

Anti Spark 5,5mm

Art. No.: JMS-ASC5
Anti Spark 5,5mm

Anti Spark 8mm

Art. No.: JMS-ASC8
Anti Spark 8mm
Partners
e-flight Esprit Hacker Hepf

Hobbytoys Topmodel.fr
Customer support:

Phone/Fax: +420 556 802 092 between 8:00 - 10:00 (CET)     |     E-mail: jeti@jetimodel.com     |     Web: www.jetimodel.com