News

Limited edition of DC/DS-24

We would like to introduce you a special limited edition of ten DC/DS-24 transmitters, which was created for the 75th anniversary of the end of World War II. Unfortunately, the release of this series last year was significantly affected by a global pandemic, which also affected our plans. The limited edition is intended for end customers, collectors and fans of JETI and is created in the spirit of flying legends of World War II. Each transmitter has original design, which was artistically painted directly on the transmitter (Airbrush).

You can find more information and photos on our Facebook profile JETI Model.

Two updates have been released via JETI Studio.

1. REX Assist v1.19 (03/2021)
Airplane pitch with Assist enabled is no longer affected by acceleration (Horizon mode).

2. MVario2 FAI F5J v2.05 (03/2021)
Supports new sensor revision.

Central Box update v1.10

New version of SW v1.10 intended for Central Box 210/220.

-Time interval of the RX alarm was modified to 2s.
-Extension the compatibility for Futaba R7008SB (S.BUS)

The update can be done by the Jeti Studio.

More news »

Accessories

Accessories

Additional accessories and electronics - available are are voltage stabilizers, electronic switches, LiIon accumulators, JETIBOX programmers and many more.

BEC Regulators, SwitchesLiIon AccuConnectorsJETIBOXJETIBOX - Assembly KitsAccessories for Tx ModulesAdditional CapacitorsRCDroidBox

Ordering

Ordering type

Show

AddCAP 10AS

Art. No.: J-AC-10AS

The AddCAP 10AS is an add-on capacitor unit that helps to insure constant voltage for your servos and receiver in large pulse current consumption power systems.

AddCAP 1640

Art. No.: J-AC-1640

AddCAP 1640 is an add-on capacitor unit designed to enhance battery power supply for drive systems using low-impedence electric motors (1-2 turns). It should also be used when the wires from your battery to your ESC need to be lengthened more than 20cm (8 inches).

AddCAP 820

Art. No.: J-AC-820

AddCAP 820 is an add-on capacitor unit designed to enhance battery power supply for drive systems using low-impedence electric motors (1-2 turns). It should also be used when the wires from your battery to your ESC need to be lengthened more than 20cm (8 inches).

Advance Pro ProgCard

Art. No.: JA-PPPC

The programming card ProgCard Pro is determined for adjustments of the Advance Plus controller family (on the side of the programming card you will find the inscription Advance ProgCard plus), as well as for adjustments of the Advance Pro controller (on the side of the programming card you will find the inscription Advance ProgCard Pro).