Basic parameters of manufactured BEC / SBEC in the table.
Menu
News
Two updates have been released via JETI Studio.
1. REX Assist v1.19 (03/2021)
Airplane pitch with Assist enabled is no longer affected by acceleration (Horizon mode).
2. MVario2 FAI F5J v2.05 (03/2021)
Supports new sensor revision.
Central Box update v1.10
New version of SW v1.10 intended for Central Box 210/220.
-Time interval of the RX alarm was modified to 2s.
-Extension the compatibility for Futaba R7008SB (S.BUS)
The update can be done by the Jeti Studio.
-Time interval of the RX alarm was modified to 2s.
-Extension the compatibility for Futaba R7008SB (S.BUS)
The update can be done by the Jeti Studio.
Transmitter update 5.04
New version SW 5.04 intended for DS-12 and DC-16II transmitters. The update can be done by the new Jeti Studio v1.1.3.
The 900MHz NG (Next Generation) backup module can be enabled (SW 5.04) after the appropriate module activation via the JETI SW shop https://swshop.jetimodel.com.
The 900MHz NG (Next Generation) backup module can be enabled (SW 5.04) after the appropriate module activation via the JETI SW shop https://swshop.jetimodel.com.
What is the basic difference between BEC and SBEC?
Linear BEC: It has a more linear output voltage then SBEC and is safer to voltage breakdown (short circuit input and output after failure). It is suitable for a smaller voltage difference between input and output, with a larger difference it starts to overheat. The ideal power supply for linear BECs with a 5-6V output are two Li-xx cells (2S).
Switched BEC: It is suitable where we want a higher supply voltage.For example, to power the BEC from the main batteries (power supply for motor). It can also "work" with a bigger voltage range (up to 59V) while keeping small dimensions.
