1. Connect the USB Adapter (or JETIBOX profi) to the PC USB port (at this stage do not connect any 
    equipment to the USB Adapter yet). If you use JETIBOX profi for the update procedure, switch it into the USB Adapter mode.
  2. Install USB Adapter drivers, which you may find on the following pages: http://www.ftdichip.com/Drivers/D2XX.htm. More recent operation systems download and install drivers automatically. 
  3. Download the latest update software from internet pages www.jetimodel.com.
  4. Start firmware update program.
  5. Connect the equipment (sensor, receiver etc.) you have chosen for updates to the USB Adapter. 
  6. Updating of the equipment firmware starts automatically.
  7. The program announces the update end. Now you may disconnect the equipment from the USB Adapter (or JETIBOX profi) and start using it. 

Update of the receiver:

Update connection - Receivers

 

Update of the sensor:

Update connection - sensor

 

 

Update steps

img img img
After launching the application, it will attempt to find the device for the update. Once you connect the device, the update starts. Do not disconnect the device now. After the updating procedure finishes, disconnect the device.